Have you ever felt some little frustration when you had to make a motor support, a gear or some other piece with epoxy resin, whereas your own wish would have been to make it with an unbreakable plastic material, transparent or maybe resistant to the heat or the abrassion? 

Have you ever looked for a polycarbonate body for a car model and you could not find it?

And a rubber tire in scale?

So, wouldn't you be able to make your own plastic pieces, with the quality and the details that you wanted? 

After studying and putting into practice each one of the techniques that are explained in this course, you won't stop being surprised by the results that you will obtain.

 "I am sure that more than one project that until today you found impossible to make will occupy again your thought throughout the hours that you can dedicate to your favorite hobby. "

                                                                                     Lic. Ricardo R. Lembo

* Copyright © 2000 Ricardo R. lembo.     

Request for more information or send us your questions and comments to:  Lic. Ricardo R. Lembo.

ü Sending your e-mail to: ricardolembo@velocom. com. ar 

ü Or writing to the postal address:  Santos Dumont 2453 - 7° - A (1426) Federal Capital. Buenos Aires - Argentina .

[ Examples ] [ Vacuum forming ] [ Injection ] [ Sending ] [ Links ] [ Downloads ]